The different qualities of Panama Hat

Foldable Panama Hat - Bailey Roll-up - Traclet boutique

There are several elements to evaluate the quality of a panama hat, here are the main ones:

The fineness of the weave

The most important element when judging the quality of a hat. Indeed, it's by looking closely that one notices the fineness of the straw diameter. If these are fine, the number of stitches per square centimeter will be higher. This number determines the overall quality of a hat. It's worth knowing that each doubling of this quality factor corresponds to a fourfold increase in the required work. This is also why a high-quality hat requires much more time.

Example: a Cuenca quality hat can take a minimum of 3 days to manufacture, while a good quality Montecristi can easily take 2 months. Be aware that unfortunately, there is no standardized measurement system and each importer has its own unit of measurement, so that one's grade 12 will mean a completely different result than another's grade 12. The same applies to derivatives such as Fino, Fino fino, Super Fino, Ultrafino, Museum, ...

The quality of the weave

Although the fineness of the weave is the most important basic factor in determining the quality of manufacture, it's the quality of the weave itself. This should be perceived according to the homogeneity and straightness over the entire surface of the hat. Of course, one should never lose sight of the fact that this is not an exact science as the weaving is done by hand and there will always be irregularities.

The color of the hat

The color of the straw varies from one hat to another because the base color of the straw used also varies. This is also why we find darker or lighter shades. What really matters is, once again, the homogeneity of the color over the entire surface. If we find areas where the shade is very visibly different, it's obvious that the overall quality suffers. Nevertheless, it's perfectly normal to detect very slight variations in the base color of the fibers, and by observing the stitches closely, one can even notice grayish or reddish lines. In Europe, often the hats are bleached to have a homogeneous color.

An example of a bleached Panama hat, here the Borsalino Panama Fedora.

The Vueltas

The rings at the center of the hat's crown (also called "Vueltas") also help determine the quality of the panama. If there are no rings, be wary! You can compare hats and their respective qualities by orienting them towards a light source to better see the number of different rings or crowns that were necessary for the assembly of the hat. These rings appear when new straw bands are added to the weave. This means that a greater number of these vueltas results in a finer and tighter weave. It ranges from 3 for an entry-level Cuenca to 8 for an entry-level Montecristi, while it goes up to 25 for a high-end one.

The number of stitches

A tedious but effective technique to determine the quality of the panama: the number of stitches per square centimeter called "Montecristi Foundation Measurement System" "Montecristi Count" (or Cuanta Montecristi).

This system consists of counting the exact number of stitches per square centimeter of the hat's surface. The most objective way to measure its fineness is therefore to count the weaving points (per inch, or about 2.5 cm). First, we measure the number of vertical weaves in a designated square centimeter, then we count the number of horizontal weaves on the same centimeter before multiplying them together to obtain the Montecristi count.

For example, we can take a weave of 25 horizontal and 30 vertical, which gives a mesh per centimeter of 750.

Mesh of the Bailey panama